Specifications
Interface Specification, GN-9386 (EtherCat Network Adapter)
Adapter Type | Slave Node (EtherCAT) |
Max. Expansion Slot | 63 slots |
I/O Data Size | Max 128 bytes each slot |
Max. Network Node | 65,535 |
Baud Rate | 100Mbps |
Bus Connection | 2 x RJ-45 |
Mac Address / IP Address | Not needed |
Other Serial Port | RS232 for MODBUS/RTU, Touch Panel or IOGuide(Crevis Software) |
Serial Configuration (RS232) | Node : 1 (Fixed) Baud Rate : 115200 (Fixed) Data bit : 8 (Fixed) Parity bit : No parity (Fixed) Stop bit : 1 (Fixed) |
Indicator | 6 Status LEDs 1 Green/Red, Module Status (MOD) 1 Green/Red, Network Status (RUN) 1 Green, Error Status (ERROR) 1 Green/Red Expansion I/O Module Statsus (IOS) 1 Green, System Power Status 1 Green, Field Power Status |
Field Power Detection | About 14Vdc |
General Specification
System Power | Supply voltage : 24Vdc nominal Supply voltage range : 16~32Vdc Protection : Output current limit (Min. 1.5A) Reverse polarity protection |
Power Dissipation | Refer to Network Adapter Manual |
Current for I/O Module | 1.5A @ 5Vdc (When using in ‘60℃ ~ 70℃’ temperature environment, the power dissipation is limited to 0.8A.) |
Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation |
Field Power | Supply voltage : 24Vdc typical (Max. 32Vdc) * Field Power Range is different depending on IO Module series. Refer to IO Module`s Specification. |
Max. Current Field Power Contact | DC 10A Max. |
Module Size | 54mm x 99mm x 70mm |