Specifications
Interface Specification, GN-9289 (Ethernet/IP & Modbus TCP/UDP Network Adapter)
| Adapter Type | Slave node (Ethernet/IP, MODBUS/TCP,MODBUS/UDP Server) |
| Protocol | Ethernet/IP and MODBUS/TCP,MODBUS/UDP,HTTP,DHCP,10 TCP Connections |
| Max. Expantsion Module | 63 slots |
| Max. Data Size(Input + Output) | Max 128 bytes each slot |
| Max Length Bus Line | Up to 100m from Ethernet Hub/Switch with twisted CAT5 UTP/STP |
| Baud Rate | 10/100Mbps, Auto-negotiation, Full duplex |
| Interface Connector | RJ-45 socket 2pcs |
| IP-Address Setup | Via DHCP/BOOTP or IOGuide(Crevis Software) |
| IP-Address Range | xxx.xxx.xxx.1 ~ 253 (User area) xxx.xxx.xxx.254 ~ 255 (Reserved for IAP Function) |
| Indicator | 6 LEDs 1 Green/Red, Module Status (MOD) 1 Green, Physical Connection (LINK) 1 Green, Exchange Data/Traffic Present (ACTIVE) 1 Green/Red, Expansion I/O Module Statsus (IOS) 1 Green, System Power Status 1 Green, Field Power Status 2 LEDs (each RJ45 Connector) 1 Yellow, Link/Active 1 Green, Not used |
| Field Power Detection | About 14Vdc |
General Specification
| System Power | Supply voltage : 24Vdc nominal Supply voltage range : 16~32Vdc Protection : Output current limit (Min. 1.5A) Reverse polarity protection |
| Power Dissipation | Refer to Network Adapter Manual |
| Current for I/O Module | 1.5A @ 5Vdc (When using in ‘60℃ ~ 70℃’ temperature environment, the power dissipation is limited to 0.8A.) |
| Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation |
| Field Power | Supply voltage : 24Vdc typical (Max. 32Vdc) * Field Power Range is different depending on IO Module series. Refer to IO Module`s Specification. |
| Max. Current Field Power Contact | DC 10A Max. |
| Module Size | 54mm x 99mm x 70mm |
