Specifications
Interface Specification, GN-9222 (Profibus Network Adapter)
Adapter Type | Slave node (ProfiBus) |
Redundancy | Not supported |
Repeater Control Signal | RS-485 Signal |
Freeze mode | Support |
Sync mode | Support |
Auto baudrate | Support |
Fail safe mode | Support |
FMS support | Not supported |
Max. Network Node | 125 Nodes |
Max. Expansion Slot | 63 Slots |
I/O Data Size | Input : 244bytes / Output : 244bytes |
Indicators | 6 Status LEDs 1 Green/Red, Module Status (MOD) 1 Green/Red, Network Status (NET) 1 Red, Diagnostic Status (DIA) 1 Green/Red Expansion I/O Module Statsus (IOS) 1 Green, System Power Status 1 Green, Field Power Status |
Communication Rate | 9.6K ~ 12M (1.2Km~100m) |
Communication Speed | 9.6 ~ 12000 Kbps (Auto baudrate selection) |
Bus Connection | 9 Pin D-Sub Connector |
Field Power Detection | About 14Vdc |
General Specification
System Power | Supply voltage : 24Vdc nominal Supply voltage range : 16~32Vdc Protection : Output current limit (Min. 1.5A) Reverse polarity protection |
Power Dissipation | Refer to Network Adapter Manual |
Current for I/O Module | 1.5A @ 5Vdc (When using in ‘60℃ ~ 70℃’ temperature environment, the power dissipation is limited to 0.8A.) |
Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation |
Field Power | Supply voltage : 24Vdc typical (Max. 32Vdc) * Field Power Range is different depending on IO Module series. Refer to IO Module`s Specification. |
Max. Current Field Power Contact | DC 10A Max. |
Module Size | 54mm x 99mm x 70mm |